adelmayer diamond spray, 0.25 micron 30ml

To make it even sharper!

The adelmayer diamond spray with different grit sizes is essential if you want your knife to be even sharper, because what good is a dull knife in the long run?

The spray is used in conjunction with the adelmayer honing leather. Apply a thin layer of diamond spray to the leather and spread evenly with your finger. The numbers 1-4 are printed on the leather for convenience.

No. 1: Start with 2 microns = 4000 grit

No. 2: With 1 micron = 8000 grit

No. 3: With 0.5 micron = 16000 grit

No. 4: With 0.25 micron = 32000 grit

Lay the knife flat on the honing leather to get the right angle.

Now lift the back of the knife at an angle of approx. 10-12°.

Always move the knife with the back first and keep an even pressure.

As soon as the back of the knife reaches the end of the strap, pull it over the leather strap at a 10° angle.

Repeat this in the opposite direction, again with the back of the knife first and at a 10° angle. Move the knife back and forth in this way.

Repeat this process eight to ten times on each side as required.

Now "break off" the angle using the diamond side so that it does not interfere with the subsequent cutting. The angle should also be roughly maintained at this point. Now work against the cutting edge without applying pressure. It is easy to imagine that you are really carving on a stick.

When the degree is gone, use the spray on the honing leather. The angle is also maintained and the knife is drawn over the honing leather with a little pressure. The honing leather turns black, which shows that you are doing everything right.